Epson printer error code 0x97

If your printer is still covered with warranty, call their customer support to run through the error with you. Call: Support Number then ask them to guide you with some fixes. Why call than run the fixes yourself? Because when the customer support fails to fix the trouble, you can actually opt to ask for a replacement. Epson printer error code 0x97 is a hardware issue and you could say your printer is basically dead. They do send replacement printers so make the most out of your warranty. It’s legit.

Fixes:

1.       Disconnect and reconnect the printer.

To do this fix, you must cancel all the print jobs first and remove any paper jams. It’s actually pretty simple and for other it worked. After getting rid of papers, unplug all cables from the printer and everything connected to it. Everything attached to it – USB, cable wires, power cords and ink cartridges. Press the power button to release any remaining power on the printer. Hold it for 60 seconds. Then, reconnect and reinstall everything. Turn on the printer and run a test print to see some improvements.

Did this work? – NO. I did print however 2 pages and the error returned. So on to fix 2.

1.       On and Off Printer

This is basically almost the same with fix no.1. You need to unplug the cables and plugs. Let the printer rest for 5 minutes. Then, press the power button for 60 seconds. Press and hold the power button while plugging back all the cables. You might need someone’s help on this one. Hold the power button for another 60 seconds then release. Run a test print and see any changes.

Did it work? Yes! For some reason this fix did the trick. But I’m going to throw in some proven solutions as well from other resources. This could help.

1.       Clean printer head

In some cases, this error could be caused by clogged print head. So the solution is to clean it. Turn off the printer and access ink cartridge compartment. Release and remove ink cartridges.

Cleaning materials:

Clean lint-free cloth

Clean water

Damp the cloth and place it on the center track (where the printer head moves). Leave the cloth there for a few hours. It will absorb all the dried ink. Remove the cloth and dry the print head. Reinstall cartridges and run a print.

I also read somewhere that the error may be caused by a malware. So install or update your malware protection to be sure.